Zeed's script AMEC 
3080 Amphere Memory Error Check

For start You need to make CUDA operations run memory at full speed. To do that use NVPI

1 Start NV profile inspector
2 Under section 5 called Common
3 Set CUDA - Force P2 State to OFF
4 Apply settings in rop right corner
Image just in case, now You are Ready to test Memory overclock for errors.


How It works:
There are 3 bat files, only difference is how long test runs.
When memory operates it warms up. Higher temperature gives bigger chance of errors that reduce performance due to error correction system on DDR6X. 
Before You not had errors but Artifacts so You knew You are pushing too far. 

First start 1 Initial check that's around 2 Minutes depending on PC's speed for fast check before Proper test
Second start 2 Check this will continue testing for around 12 minutes SHOULD BE ENOUGH for gaming
Third start 3 for long 30 minute STRESS TEST 

After each test ends it creates txt file with date of test, Open the file  to see if and how many errors occured.
Depending on outcome increse or reduce memory overclock by standard 25mhz and retest.

ps.You can stop test by spamming x
